Nortek Security and Control KB

DXSR-1504/1508 - Factory Default

Note: This erases all transmitters and resets all parameters to factory defaults.

  1. Remove the Program Jumper
  2. Remove power for at least ten seconds
  3. Press and hold program buttons #1 and #2
  4. Apply power
  5. Release program buttons #1 and #2

Pressing the program buttons (one at a time) will display the button number and activate the output for that channel.

Power unit down, install program jumper and apply power to return to normal mode.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I reset the master code on my security panel?
Viewed 3849 times since Mon, Mar 29, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I set my extended range transmitter and receiver to work together?
Viewed 3340 times since Mon, Apr 5, 2010
How do I program a transmitter into a DXSR-1504 and DXSR-1508?
Viewed 3016 times since Fri, Mar 12, 2010
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010
DXS-73 Smoke Detector - Replacing the battery
Viewed 2919 times since Mon, Jul 30, 2012
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010