Nortek Security and Control KB

DXS-73 Smoke Detector - Replacing the battery

After removing the old battery, you need to wait at least 15 seconds before installing the new battery; this gives the low-battery circuit time to reset. If the new battery is inserted too soon, a low battery signal will continue to be sent along with hourly status transmissions.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I reset the master code on my security panel?
Viewed 3849 times since Mon, Mar 29, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I set my extended range transmitter and receiver to work together?
Viewed 3340 times since Mon, Apr 5, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010