Nortek Security and Control KB

How do I program my MegaCode series keypad into my LDCO800 garage door operator?

The Linear LDCO800 series garage door operators use the MegaCode series keypad, model MDTK, part number DNT00058. To program a MegaCode series keypad to the LDCO operator, simply press and release the "LEARN" button located in the center of the back of the motor unit in your garage. The red LED above the "LEARN" button will come on bright for 15 seconds. While the LED is on, enter your code (the code can be from 1 to 6 digits long) and press the "Start/Stop" button on the keypad. The light on the operator will blink once to confirm receipt of the code.
1.4 (5)
Article Rating (5 Votes)
Rate this article
Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code