Nortek Security and Control KB

How do I install the DXS-62A petite wristband?

Installing the petite wristband can be a real challenge!

The trick is to leave the standard band’s plastic pieces (the strap adapters) attached to the body of the remote, then either use scissors to cut off the old band, or a sharp pocket knife to compress and remove the spring pin that holds the strap in place (wear eye protection). No matter which method you use to remove the band, you need to compress and remove the two spring pins.

With the remote lying on a flat surface with the back facing up, place the new band across the back of the remote, roughly centered along the length of the strap, with the side that touches the wrist, also facing up. Make sure the buckle will be in a comfortable location after installation. You may want to place the strap on the user and mark the approximate location of the remote.

Take one of the spring pins and, compressing the strap, place it in one of the holes of the strap adapter.

Now you need to take the pocket knife and carefully compress the spring pin and guide it into the other hole in the strap adapter. This "traps” the new band under the pin.

Do the same thing with the other spring pin.

Now the wrist strap should lie across the back of the remote and run under the two spring pins.

Normally you would adjust the strap to fit the end user so it’s tight enough to stay in place, but loose enough to slide off over their hand, without disturbing the adjustment, should they wish to remove it. You can remove the excess strap with a pair of scissors. A bit of fingernail polish or "super glue” on the cut end of the strip will prevent unraveling.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
What material is used for DXS-LR series wristband?
Viewed 1179 times since Thu, Mar 5, 2015
What is the battery life of my PERS transmitters?
Viewed 2440 times since Mon, Mar 29, 2010
How do I use the activity timer?
Viewed 2337 times since Wed, Mar 31, 2010
What does the trouble Indicator do on my PERS unit?
Viewed 2158 times since Thu, Jun 23, 2011
Dealership Logo on PERS
Viewed 2058 times since Tue, Oct 11, 2011
PERS Operational Range
Viewed 2027 times since Tue, Oct 11, 2011
How do I delete a transmitter in a PERS console?
Viewed 2356 times since Thu, Jul 7, 2011
Is there a solution for a Customer that switches from an Analog phone to a VOIP service?
Viewed 3250 times since Wed, May 2, 2012
Can I change the battery in my DXS-62A?
Viewed 2862 times since Thu, Jul 7, 2011
PERS standard wrist band doesn’t fit
Viewed 2295 times since Tue, May 1, 2012