Nortek Security and Control KB

How do I change the Hub Modem ring settings?

The following are instructions for connecting your Hub Modem to your PC for setting the modem string.

Before getting started you must disable remote communication in your module: 31 # 8 # 0 # **

USB Converter to Hub Modem Connection

Power Modem with 12VDC power supply to V+ and V- terminals.

Converter to Hub Modem:
  • Green Wire to P2 Blue Terminal
  • Blue Wire to P2 Gray Terminal
  • Black Wire to P2 Green Terminal

COM port to Hub Modem Connection

Power Modem with 12VDC power supply to V+ and V- terminals.

You need a DB connector, 6-foot cord and external RJ-11 jack.
  • Black wire to P2 Blue terminal
  • Green wire to P2 Green terminal
  • Red wire to P2 Gray terminal

USB Converter to Backplane Connection

Leave modem plugged onto backplane and set SW2 to Remote Setting. Remove the Max module but leave SW1 in the ON position.

USB Converter to Backplane:
  • Green Wire to A1
  • Blue Wire to A0
  • Black Wire to GND

COM port to Backplane Connection

Leave the modem plugged into the backplane. Remove the Max module, but leave SW1 in the ON position. Using DB connector plug the 6-foot cord into RJ-11A and set SW2 to Remote Setting.

Hyperterminal Settings
  • Bits per second: 1200
  • Data bits: 8
  • Parity: None
  • Stop bits: 1
  • Flow control: None

When using a serial COM port you must select the COM port you are connecting to. When using a USB port you must verify the COM port number in device manager windows assigns to your converter.

Hyperterminal AT commands

To set modem to answer on one ring enter the following commands in hyperterminal:

  • AT <enter> Wait for OK result
  • ATS0=1&W0 <enter> Wait for OK result
  • Exit hyperterminal
Note: For a different number of rings change the 1 in the command about to the desired number of rings. For example for 2 rings type ATS0=2&W0.
1 (2)
Article Rating (2 Votes)
Rate this article
Attached Files
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
Security Code Security Code
Related Articles RSS Feed
I am not getting access with my cards.
Viewed 5806 times since Mon, Mar 15, 2010
How do I install the USB Driver?
Viewed 1513 times since Tue, Feb 3, 2015
I received a ’Device is not connected or unexpected device type’ error message while trying to export to the door controller.
Viewed 6770 times since Thu, Apr 15, 2010
I am trying to upgrade using my backup and it does not work.
Viewed 4505 times since Wed, Mar 24, 2010
How do I update Hub Manager® Pro?
Viewed 9941 times since Thu, Mar 11, 2010
I can’t open my downloaded installer program
Viewed 2747 times since Fri, May 14, 2010
I can no longer communicate with my ProxPad or Max3 using the USB to Serial Converter on a Single Gang Plate.
Viewed 4535 times since Thu, Jul 1, 2010
How do I use the Lantronix Device Installer to program a Seg?
Viewed 2539 times since Wed, Jan 20, 2016
Hub Manager®: com port is not working and the USB driver is installed
Viewed 5495 times since Mon, Apr 19, 2010
How do I retrieve my list of users and controller settings?
Viewed 3139 times since Mon, Mar 15, 2010