How do I change the Hub Modem ring settings?
Before getting started you must disable remote communication in your module: 31 # 8 # 0 # **
USB Converter to Hub Modem Connection
Power Modem with 12VDC power supply to V+ and V- terminals.
Converter to Hub Modem:- Green Wire to P2 Blue Terminal
- Blue Wire to P2 Gray Terminal
- Black Wire to P2 Green Terminal
COM port to Hub Modem Connection
Power Modem with 12VDC power supply to V+ and V- terminals.
You need a DB connector, 6-foot cord and external RJ-11 jack.- Black wire to P2 Blue terminal
- Green wire to P2 Green terminal
- Red wire to P2 Gray terminal
USB Converter to Backplane Connection
Leave modem plugged onto backplane and set SW2 to Remote Setting. Remove the Max module but leave SW1 in the ON position.
USB Converter to Backplane:- Green Wire to A1
- Blue Wire to A0
- Black Wire to GND
COM port to Backplane Connection
Leave the modem plugged into the backplane. Remove the Max module, but leave SW1 in the ON position. Using DB connector plug the 6-foot cord into RJ-11A and set SW2 to Remote Setting.
Hyperterminal Settings- Bits per second: 1200
- Data bits: 8
- Parity: None
- Stop bits: 1
- Flow control: None
When using a serial COM port you must select the COM port you are connecting to. When using a USB port you must verify the COM port number in device manager windows assigns to your converter.
Hyperterminal AT commands
To set modem to answer on one ring enter the following commands in hyperterminal:
- AT <enter> Wait for OK result
- ATS0=1&W0 <enter> Wait for OK result
- Exit hyperterminal