How do I wire a strobe light or siren to my receiver?
Article ID: 416 | Rating: 1/5 from 1 votes | Last Updated: Tue, Nov 20, 2012 at 4:23 PM
All Linear receivers that use "dry contact" outputs do not supply voltage from the relays. This means that the receiver does not supply the voltage for the door strike or magnetic lock. You will need a power supply that supplies the correct voltage and sufficient current to operate the door strike or magnetic lock. You can use a single power supply for both the receiver and the door strike or magnetic lock if both the receiver and the lock use the same voltage and the power supply provides sufficient current to operate both devices.You will switch one leg of the power supply for the door strike or magnetic lock through the relay on the receiver.
The wiring would be connected as follows:
NOTE: Make sure that the current draw of the door strike or magnetic lock does not exceed the current rating of the relay in the receiver.
- Wire one side of the power supply to the common on the receiver relay.
- Wire one side of the strobe light or siren to the N/O (normally open) contact on the receiver relay.
- Wire the other side of the strobe light or siren to the other side of the power supply.
There are no attachments for this article.
There are no comments for this article. Be the first to post a comment.
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010