Nortek Security and Control KB

How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?

The Extended Range Transmitter can be set to send a Status signal every hour. If the Extended Range Receiver does not receive a Status signal from the correct transmitter, the receiver will activate the Status output on the receiver after 4 hours.

The Status option is set by Option Switch 5 on the XT-1 transmitter, and Option Switch 3 on the XT-4 transmitter. If the option switch is set to OFF, then the transmitter does not send a Status signal. If the option switch is set to ON, then the transmitter sends a Status signal every hour.

The Status function is turned on in the Extended Range Receiver by setting the correct option switch to the ON position in the Extended Range Receiver. In the XR-1 receiver this would be Option Switch 3. In the XR-4 receiver this would be Option Switches 1, 2, 3, or 4, depending on which channel or channels need to be monitored.

In the XR-16 receiver this would be Option Switches 1 thru 16, depending on the channel or channels that need to be monitored.

NOTE: The Status function cannot be used when using an Extended Range Hand Held Transmitter. There is not an option to turn on Status Reporting in these transmitters.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
DXS-73 Smoke Detector - Replacing the battery
Viewed 2919 times since Mon, Jul 30, 2012
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010