Nortek Security and Control KB

How do I set the output to latch on my Extended Range Receiver?

The output on an Extended Range Receiver can be set to function in one of two ways. It can be set for manual or auto restoral. Manual restore is used when you want the output of the Extended Range Receiver to follow the input of the Extended Range Transmitter. This would be a toggle or latch type of operation. Auto restore is used when you want the output from the Extended Range Receiver to reset independent of what the input to the Extended Range Transmitter is doing. This function is set by an option switch in the transmitter. Option switch 6, in the XT-1, and option switch 4, in the XT-4 determines which mode is used. The off position sets the receiver for manual restore. The on position sets the receiver for auto restore. Note: This function is not available when using the Extended Range Hand Held Transmitters. The output on the receiver will activate for as long as the transmitter button is pressed, up to 30 seconds. After 30 seconds the transmitter stops transmitting and the output will de-activate.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I set my extended range transmitter and receiver to work together?
Viewed 3340 times since Mon, Apr 5, 2010
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010