Nortek Security and Control KB

How do I set my extended range transmitter and receiver to work together?

The System Code that is sent by the Extended Range Transmitter is set using the System Code Switches. The System Code Switches are 2 sets of 8 switch dipswitch packs set side by side on the transmitter board. These dipswitches can be set in any combination of on or off that is desired. The System Code Switches in the Extended Range Receiver set the code that the receiver responds too. The System Code Switches in the Extended Range Receiver must be set to the same settings as the System Code Switches in the Extended Range Transmitter.In the XT-4, XT-2H and the XT-4H transmitters there are 2 option dipswitches that set the bank of channels sent by the transmitter. In the XT-1 and XT-1H transmitters there are 2 option dipswitches to set the bank of channels and 2 option dipswitches that set the channel sent by the transmitter. There are 4 banks of 4 channels that can be selected. In the XR-1 receiver there are 2 option dipswitches to set the channel that the receiver responds too. The receiver can only respond to channels 1, 2, 3 or 4 sent from the transmitter. The XR-4 receiver responds to only channels 1, 2, 3, and 4 sent from the transmitters.The XR-16 receiver responds to all 16 channels that can be sent by the transmitters.

Note: The 2 bank option dipswitches in all transmitters must be set to off if transmitting to a XR-1 or XR-4 receiver.

1 (2)
Article Rating (2 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
How do I program a transmitter into a DXSR-1504 and DXSR-1508?
Viewed 3016 times since Fri, Mar 12, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010