Nortek Security and Control KB

How do I program a PERS console?

  1. Perform the steps detailed in the RA-2400/PERS-2400 reference guide to setup the RA-2400 program.
  2. To locally program the console, connect the modems line jack to the console line jack.
  3. Press the "Test Button" momentarily.
  4. When the RA-2400 connection timer starts counting down, press the "Emergency Button" to turn the phone on.
  5. Perform the programming steps in the RA-2400 software and after sending the programming to the console, then disconnect from the console.
0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Can you "Arm or Disarm the PERS Consoles"?
Viewed 2057 times since Mon, Mar 29, 2010
What Modem do I use to program my PERS?
Viewed 2994 times since Thu, Jul 7, 2011
What happens if I change the password on my PERS systems as a Dealer and I forget the password?
Viewed 2124 times since Thu, Jun 23, 2011
Can I talk through my transmitter to the PERS console?
Viewed 2194 times since Thu, Jul 7, 2011
Can I change the battery in my DXS-62A?
Viewed 2862 times since Thu, Jul 7, 2011
Wall Mounted Transformers keep falling out.
Viewed 2998 times since Tue, Oct 11, 2011
How is the audio mode selected?
Viewed 2231 times since Thu, Jul 7, 2011
PERS 2-way voice coverage & transmitter range
Viewed 2940 times since Tue, May 1, 2012
Does Linear offer Wander Management?
Viewed 1938 times since Tue, Oct 11, 2011
Is there a solution for a Customer that switches from an Analog phone to a VOIP service?
Viewed 3250 times since Wed, May 2, 2012