Nortek Security and Control KB

How do I "Setup Supervision" in my PERS Consoles?

If the two hour status timer is required for supervision, permanently enable the timer by pressing the transmitter button five times in succession within four seconds. When the DXS-62A is in the supervised mode, the LED signal indicator will blink rapidly during activation.

Program the transmitter into the consoles by placing the console into program mode. Then send a signal to the console from the transmitter, refer to the receivers programming instructions for details.

Transmitter low battery trouble, transmitter supervisory trouble. Note: The console will announce the supervisory conditions with the optional model "VB-4B" voice board installed. The voice can be disable though programming, when a transmitter sends a low battery the console’s trouble indicator will blink slowly. If a transmitter programmed as supervised fails to report status in a 24 hour period, the consoles trouble indicator will light.

Console backup battery trouble, the console will test its backup battery every 8 hours, if the battery tests low, the power indicator will blink slowly while the console charges the battery.

Clearing trouble indications; press the clear button to stop trouble indicators and sounders the console will report trouble and/or 30 day status to the central stations if enabled in the communicator programming.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Does the PERS Console or DX transmitter emit radiation?
Viewed 2545 times since Thu, Nov 11, 2010
Turn PERS Off at end of contract
Viewed 2891 times since Tue, May 1, 2012
Can I change the battery in my DXS-62A?
Viewed 2862 times since Thu, Jul 7, 2011
Programming PERS-2400 and PERS-3600.
Viewed 3909 times since Tue, Oct 11, 2011
Does the PERS have line seizure?
Viewed 2371 times since Mon, Mar 29, 2010
Digital Voice (IP based) telephone networks and PERS
Viewed 3350 times since Tue, May 1, 2012
What material is used for DXS-LR series wristband?
Viewed 1179 times since Thu, Mar 5, 2015
What Modem do I use to program my PERS?
Viewed 2994 times since Thu, Jul 7, 2011
Can I talk through my transmitter to the PERS console?
Viewed 2194 times since Thu, Jul 7, 2011
Does Linear offer Wander Management?
Viewed 1938 times since Tue, Oct 11, 2011