Nortek Security and Control KB

How do I change the keypad code for my Linear garage door operator?

The Linear series of garage door operators uses the model MDTK keypad, part number DNT00058. This keypad has no memory, and acts only as a transmitter.

In order to change the keypad code, you must erase the memory in the LDO/LSO/LCO. If you will look at the upper right hand corner of the left hand side of the LDO/LSO/LCO, you will see the learn button. Simply press and hold this button for 10 seconds or more. When you release the learn button, the red LED above the button will blink 3 times and then come on bright for 15 seconds. When the LED goes out, the memory in the operator is erased. To learn in a new keypad code, press and release the learn button. The LED will come on for 15 seconds. While the LED is on, go to your keypad and enter your desired code (1 to 6 digits long) and press start/stop on the keypad. The LED will blink to indicate receipt of the new code. You will also have to reenter all of your hand held remotes into the memory.

Again, simply press and release the learn button. When the LED comes on, press the button on the remote you wish to use. Repeat for any additional remotes. If you hold the learn button down for 10 seconds or more, you will have to start over, since the memory will be erased again.

3.13 (31)
Article Rating (31 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I program my transmitter to my Linear garage door operator?
Viewed 81282 times since Mon, Mar 29, 2010
How do I find the serial number of my LDO/LSO/LCO operator?
Viewed 3664 times since Thu, Jul 7, 2011
Why will the remote open my Linear garage door operator, but not close it?
Viewed 28135 times since Tue, Mar 30, 2010
How do I learn a transmitter into my LDCO800?
Viewed 4867 times since Tue, Apr 5, 2011
How do I increase the force setting on my LDCO800 operator?
Viewed 3529 times since Tue, Apr 5, 2011
How do I set the travel limits on my LDCO800?
Viewed 4652 times since Tue, Apr 5, 2011
How do I program my car’s Lear system to operate my Linear garage door operator?
Viewed 12522 times since Mon, Mar 29, 2010
The chain is vibrating on my Linear garage door operator when the door is opening or closing.
Viewed 4178 times since Fri, May 14, 2010
Can I add a second wall button to my LDO/LSO/LCO series operator?
Viewed 3575 times since Mon, Apr 19, 2010
How do I program my Allstar Quick Code Classic remote?
Viewed 16186 times since Fri, May 7, 2010