Nortek Security and Control KB

How do I set the travel limits on my Linear garage door operator?

Travel limits are set on the LDO/LSO/LCO series operators by adjusting the limit adjusting screws accessed through the holes on the left hand side of the operator. These are marked "CLOSE LIMIT" and "OPEN LIMIT."

Turning the appropriate adjustment screw clockwise will cause the door to stop at a higher position. Turning the appropriate adjusting screw counterclockwise will cause the door to stop at a lower position. One complete turn of the screw will change the stopping point by about 2.5 inches.
1 (2)
Article Rating (2 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code