Nortek Security and Control KB

How do I program a transmitter into a security panel?

  1. Use your Master Code, then hit "Test" button once to go into the Test mode.
  2. Use your Master Code and "Test" button again to get into programming.
  3. Input the zone number for the transmitter, then activate the transmitter.
  4. Hold down the "Off" key to exit programming.
0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I program a transmitter into a DXSR-1504 and DXSR-1508?
Viewed 3016 times since Fri, Mar 12, 2010
How do I reset the master code on my security panel?
Viewed 3849 times since Mon, Mar 29, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
DXS-73 Smoke Detector - Replacing the battery
Viewed 2919 times since Mon, Jul 30, 2012
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010