Nortek Security and Control KB
Home » Categories » Security

How do I reset the master code on my security panel?

Article ID: 288 | Rating: 1/5 from 2 votes | Last Updated: Tue, Nov 20, 2012 at 11:37 AM

Without knowing the master code, you are unable to reset the master password.
You can try and dial into the unit with the RA-2400 software and see what the master code is. This can only be done if the remote access password has not been changed from the default 9 8 7 6 5 4.
Posted by: - Mon, Mar 29, 2010 at 2:36 PM. This article has been viewed 3849 times.
Filed Under: Security
1 (2)
Article Rating (2 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
DXS-73 Smoke Detector - Replacing the battery
Viewed 2919 times since Mon, Jul 30, 2012
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
How do I program a transmitter into a DXSR-1504 and DXSR-1508?
Viewed 3016 times since Fri, Mar 12, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010