Nortek Security and Control KB

How do I program a transmitter into a PERS?

To program a single transmitter into the PERS-2400 simply press and hold the "CLEAR" button for five seconds or until you hear five beeps. The unit is now ready to accept the transmission from the DX or DXS transmitter. After transmission is received, the PERS will beep once, then return to the normal operation mode.

To program a single transmitter into the PERS-3600, press and hold the "CANCEL" button for five seconds or until the console announces "Ready To Learn Sensor". Unit is now ready to accept the transmission from the DX or DXS transmitter. After transmission is received, the PERS will announce "Emergency Sensor Learned" and then return to normal operation mode.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Programming PERS-2400 and PERS-3600.
Viewed 3909 times since Tue, Oct 11, 2011
Is there a solution for customers that do not have an analog POTS line?
Viewed 3346 times since Tue, May 1, 2012
Self install PERS
Viewed 2063 times since Tue, Oct 11, 2011
Is there a solution for a Customer that switches from an Analog phone to a VOIP service?
Viewed 3250 times since Wed, May 2, 2012
Pre-recorded tutorial for PERS
Viewed 2924 times since Tue, Oct 11, 2011
Do the PERS-2400 & PERS-3600 have a "backup battery?"
Viewed 2994 times since Tue, May 1, 2012
Status Reporting for DXS-LR Series Transmitters
Viewed 2075 times since Fri, Sep 6, 2013
Does the PERS Console or DX transmitter emit radiation?
Viewed 2545 times since Thu, Nov 11, 2010
How is the audio mode selected?
Viewed 2231 times since Thu, Jul 7, 2011
Wall Mounted Transformers keep falling out.
Viewed 2998 times since Tue, Oct 11, 2011