Nortek Security and Control KB

How do I program a transmitter into a PERS?

To program a single transmitter into the PERS-2400 simply press and hold the "CLEAR" button for five seconds or until you hear five beeps. The unit is now ready to accept the transmission from the DX or DXS transmitter. After transmission is received, the PERS will beep once, then return to the normal operation mode.

To program a single transmitter into the PERS-3600, press and hold the "CANCEL" button for five seconds or until the console announces "Ready To Learn Sensor". Unit is now ready to accept the transmission from the DX or DXS transmitter. After transmission is received, the PERS will announce "Emergency Sensor Learned" and then return to normal operation mode.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
PERS 2-way voice coverage & transmitter range
Viewed 2940 times since Tue, May 1, 2012
Can I change the battery in my DXS-62A?
Viewed 2862 times since Thu, Jul 7, 2011
How do you program in reminder messages into the PERS-3600?
Viewed 2142 times since Thu, Jul 7, 2011
How do I program a PERS console?
Viewed 2701 times since Thu, Jul 7, 2011
PERS and older customers
Viewed 2609 times since Tue, Oct 11, 2011
What is voice-activated two-way audio?
Viewed 2408 times since Thu, Jul 7, 2011
How many remote microphones and speakers can you connect to the PERS consoles?
Viewed 2890 times since Thu, Jul 7, 2011
PERS Operational Range
Viewed 2027 times since Tue, Oct 11, 2011
Linear Learning for PERS
Viewed 1885 times since Tue, Oct 11, 2011
What does the trouble Indicator do on my PERS unit?
Viewed 2158 times since Thu, Jun 23, 2011