Nortek Security and Control KB

How do I program a transmitter into a SXR-64A?

  1. With the panel disarmed, press the UP or DOWN button until the desired receiver channel number (1-64) is displayed - Memory light will be off if the receiver channel is vacant (only a vacant channel will accept a transmitter)
  2. Press the ADVANCE button to select the output zone (channel) number (1-8) for the displayed receiver channel number
  3. Press the MEMORY button once (the memory light will blink)
  4. Activate the transmitter
  5. The MEMORY light will go on, showing that the transmitter was entered and the receiver’s displayed channel is occupied
  6. Exit programming by pressing the UP and DOWN buttons at the same time
0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
How do I set my extended range transmitter and receiver to work together?
Viewed 3340 times since Mon, Apr 5, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010