Nortek Security and Control KB
Home » Categories » Security

How do I program a transmitter into a DXSR-1504 and DXSR-1508?

Article ID: 231 | Rating: Unrated | Last Updated: Wed, Nov 28, 2012 at 12:38 PM
  1. Remove the receiver’s cover
  2. On the receiver, locate and remove the program jumper
  3. Prepare the new remote to send a signal
  4. On the receiver, press and release the program button for the desired channel
  5. While the channel light is visible in the display, activate the transmitter
  6. On the receiver, replace the program jumper and test the transmitter
Posted by: - Fri, Mar 12, 2010 at 7:44 PM. This article has been viewed 3016 times.
Filed Under: Security
0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I program a transmitter into a DXR-701 and DXR-702?
Viewed 6435 times since Mon, Mar 22, 2010
How do I program or delete a transmitter in a CP90?
Viewed 2559 times since Wed, Mar 31, 2010
Can I program with a telephone?
Viewed 2465 times since Mon, Mar 22, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010
How do I reset the master code on my security panel?
Viewed 3849 times since Mon, Mar 29, 2010
How do I wire a door strike or magnetic lock to my receiver?
Viewed 8730 times since Wed, Apr 14, 2010
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010