Nortek Security and Control KB

How do I program or delete a transmitter in a CP90?

  1. Enter the programming mode by pressing "9", then the Master Code (default: 98765).
  2. Press "2", then "???" (the second button down in the left column of buttons.
  3. Enter an unused transmitter location.
  4. Press the "???" (the second button down in the left column of buttons).
  5. Press "STORE" (the top button in the left column of buttons).
  6. Activate the transmitter.

You should hear three ascending tones indicating the panel accepted the program step.
Press and hold the " * " (star) button to exit programming.

DELETE A TRANSMITTER
  1. Enter the programming mode by pressing "9", then the Master Code (default: 98765).
  2. Press "3" ,then "???" (the second button down in the left column of buttons).
  3. Enter the transmitter number 4 – 64 and press "???."
  4. Press "STORE" (the top button in the left column of buttons).

You should hear three ascending tones indicating the panel accepted the program step.
Press and hold the * (star) button to exit programming.

0 (0)
Article Rating (No Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
How do I set the output to latch on my Extended Range Receiver?
Viewed 2442 times since Mon, Apr 5, 2010
Is the DXS-80, CO Detector UL listed?
Viewed 2497 times since Tue, Apr 13, 2010
How do I program a transmitter into a DXSR-1504 and DXSR-1508?
Viewed 3016 times since Fri, Mar 12, 2010
How do I arm and disarm my system?
Viewed 2467 times since Mon, Mar 29, 2010
DXSR-1504/1508 - Factory Default
Viewed 3108 times since Mon, Mar 8, 2010
How do I wire a strobe light or siren to my receiver?
Viewed 3541 times since Thu, Apr 8, 2010
How do I set my extended range transmitter and receiver to work together?
Viewed 3340 times since Mon, Apr 5, 2010
How do I program a transmitter into a SXR-64A?
Viewed 2762 times since Mon, Mar 15, 2010
How do I program a transmitter into a security panel?
Viewed 2555 times since Mon, Mar 29, 2010
How do I setup my Extended Range Transmitter and Receiver for Status or Supervisory operation?
Viewed 2658 times since Thu, Apr 8, 2010