Nortek Security and Control KB

How do I program my Stanley keypad?

First, erase the keypad’s memory by disconnecting the battery and holding any key (button) for at least 10 seconds. Then release the key and re-connect the battery. When the keypad lights go off (about 20 seconds) you are ready to program the keypad.

Second, obtain a working remote and remove the battery door (cover). Inside you will see 10 code-setting rocker switches. These switches can be either on or off. The switches are on when they are pressed down toward the numbers and off when they are up by the numbers. Take note of the switches that are pressed down by the number, since these switches are on. Switches 1-9 are entered in the radio code as 1-9, but since there is no number 10 on the keypad, you would enter it as 0 (zero). For instance, if switches 2 4 6 8 & 10 are pressed down by the number, the radio code to enter in the keypad Radio Learn mode would be 2 4 6 8 0.

To enter the radio code:
  1. Press Radio Learn 2 times.
  2. Enter 1 2 3 4 .
  3. Enter the radio code (obtained from a working remote).
  4. Press Radio Learn 1 time.
  5. Enter 1 2 3 4 (the default access code) and note if the gate or door operates.
  6. If the gate or door operates, you can now set the Access Code (the code you will use to open the gate or door).
To enter the access code:
  1. Wait until the keypad lights go off (about 20 seconds).
  2. Press Access Learn 2 times .
  3. Enter 1 2 3 4.
  4. Enter your desired 4-digit access code.
  5. Press Access Learn 1 time.
  6. Now, enter your new access code to make sure it works.
4.8 (10)
Article Rating (10 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
Find Transmitter Code - AP-4, AP-5
Viewed 4621 times since Wed, Mar 31, 2010
Remotes have poor range
Viewed 4697 times since Tue, Feb 26, 2013
How do I increase the range on my radio receiver?
Viewed 12376 times since Thu, Jun 23, 2011
Will Allstar work with MVP?
Viewed 2721 times since Mon, Mar 29, 2010
The relay chatters when I trigger the door strike
Viewed 2545 times since Thu, Apr 12, 2012
What products will Multicode work with?
Viewed 3840 times since Mon, Mar 29, 2010
How much and what type of voltage does my receiver use?
Viewed 2744 times since Thu, Apr 8, 2010
Program a MCS420001 Keypad
Viewed 3985 times since Mon, May 16, 2011
How do I make my clicker brand transmitter work with my Linear garage door operator?
Viewed 4529 times since Mon, Mar 29, 2010
How do I program my DTKP keypad?
Viewed 3933 times since Mon, Mar 29, 2010