Nortek Security and Control KB

How do I program my DTKP keypad?

The code that will be used at the DTKP will depend on how the receiver’s 8 position dipswitches are set. The switches that are set to the "ON" position will be the user’s pin at the DTKP keypad in reverse.

Example: If the receiver’s dipswitches 1, 3, 5, and 8 are set to the "ON" position then the user’s PIN would be (8-5-3-1-START/STOP).

3 (1)
Article Rating (1 Votes)
Rate this article
Attached Files
There are no attachments for this article.
Comments
There are no comments for this article. Be the first to post a comment.
Name
Email
Security Code Security Code
Related Articles RSS Feed
The relay chatters when I trigger the door strike
Viewed 2545 times since Thu, Apr 12, 2012
Find Transmitter Code - AP-4, AP-5
Viewed 4621 times since Wed, Mar 31, 2010
Program a MCS420001 Keypad
Viewed 3985 times since Mon, May 16, 2011
How do I make my clicker brand transmitter work with my Linear garage door operator?
Viewed 4529 times since Mon, Mar 29, 2010
Remotes have poor range
Viewed 4697 times since Tue, Feb 26, 2013
How do I program my MVP keypad?
Viewed 5285 times since Wed, Apr 7, 2010
Open Collector Output
Viewed 3283 times since Fri, Jul 8, 2011
What products will Multicode work with?
Viewed 3840 times since Mon, Mar 29, 2010
How do I program my MDTK keypad?
Viewed 4845 times since Mon, Mar 29, 2010
Will Allstar work with MVP?
Viewed 2721 times since Mon, Mar 29, 2010